Drew Technologies DashDAQ Series II Manual de instrucciones descargar pdf (Pagina 16)

6. To select the Innovate LC-1, use the [<] or [>]

buttons to navigate to the “Wideband”

selection.

7. Tap [Innovate LC-1] to highlight the Innovate

LC-1 driver. Tap [Save].

8. Tap [Save] again. Tap [Save] once more at

the Installed Device setup window.

To make use of the driver after it has been

selected:

1. Tap on [Gauges] from the Main Menu.

2. Tap on a gauge you would like to assign the

Innovate LC-1 signal to.

3. Tap [Assign Signal].

4. Use the [<] or [>] buttons to navigate to the

Innovate LC-1 heading. Tap [Air-Fuel Ratio]

to highlight.

5. Tap [Save]. Tap [Save] again at the Assign

Signal Screen.

This procedure can be repeated for all drivers

found in the Installed Devices setup option.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Sin comentarios

Drew Technologies DashDAQ Series II Manual de instrucciones Pagina 16