Drew Technologies DashDAQ Series II Manual de instrucciones descargar pdf (Pagina 12)

3.3

Set Gauge Min/Max Values

The DashDAQ allows users to specify the data

range for each gauge. Tap on the [Minimum] button

to set the bottom value for a gauge. Tap on the

[Maximum] button to set the top of the gauge.

When you tap on either [Minimum] or [Maximum]

this screen will appear:

Tap in the desired value. Tap [+/-] to make this

value negative.

3.4

Set Gauge High/Low Warning

The High/Low Warning allows users to set the

visual representation of “redline” on a gauge.

For example: If the gauge has a maximum value of

6,000 and you set a High Warning of 5,000, the

gauge will visually represent a “danger zone” on

the gauge.

To set a High/Low Warning:

1. Tap on the gauge that a High/Low Warning is

to be set.

2. At the Assign Signal screen, tap on either

High or Low Warning.

3. Tap the numbers to enter the desired value.

Tap [+/-] to make the value negative. Tap

[Save].

4. Tape [Save] at the Assign Signal screen to

go back to the gauges.

3.5

Setting Signal/Graph Colors

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Sin comentarios

Drew Technologies DashDAQ Series II Manual de instrucciones Pagina 12